The new machine connectivity admin panel upload possibility was not shown as expected. The section is now available as expected.
When the Material Inventory is enabled, the stock level graph was not loading properly. It now loads correctly.
The stock level graph now updates when material lots are added or edited.
The Material lot assignment field was shown on the job detail view even if the Material Inventory was not enabled. This is fixed.
Downloading a Production sheet from the Part list now works correctly again.
It was still possible to unassign a workflow from a deleted part, although no action at all should be available for deleted parts.
Finishing a job now correctly prompts to update the order status if all sequences are finished when the job finishes.

Hotfix 22.7.2 - 2022-

...

09-

...

We fixed a bug where STL files deleted via the admin panel prevented the part list to load.
We fixed a bug that caused the display of an error message when bulk-updating part statuses from the part list, event even though the update succeeded.
We fixed backwards the backward compatibility of old Part URLs not using the new short-ID format yet, these old Part URLs now work again.
An issue with importing certain CSV files was fixed.
We fixed an issue causing an error toaster to be displayed when performing bulk status updates from the part list.

...

We fixed an issue causing the wrong error messages being to be displayed in the 3D viewer of the basket.
When uploading any format other than .STL into the basket the MM-INCH switch was not working. It now works for all of the supported file formats.

Changing a part’s workflow order was not reflected correctly on the sequences of the part. This is now fixed.
The “To schedule” column now correctly sorts by the sequences that are still to be scheduled (as opposed to sorting by the total number of sequences).

...